I had originally set mix it up to filter single and doubles on load and that worked great (because all share into that category) but when I set to jtex base I can’t seem to get the reset button to work properly. Rather than showing my all beds it just shows me jtex.
It seems a bit of a complex question but it will make sense when you see the pen.
Basically I just want to show Jtex bases on load and then when the user clicks show all for all beds to show jtex and slatted.
I’ve been messing around with the code and I can’t figure it out.
Any help will be massively appreciated.
Thanks in advance Ricky
Viewing 1 post (of 1 total)